300DS pressure plate assembly

Quick Details

Specification: 300*190 installation hole: 10 x phi 11 12 x Phi 11 models: Wuxi 4110, Yuchai YC4110, chaochai CY4105Q, cloud 4100ZQ, CY4105Q, CYQD32Ti, CA498ZQ DL, CA4100, CA4D32, YZ4110QA, Yang Chai, 4100 models: Foton, FAW Hongta, Jianghuai JAC light truck, Jinlong bus, Dongfeng light card EQ1048G46D, Dongfeng, Yutong,   bus beauty; above product information for reference note the use of
1 driven disc assembly should be kept clean, the friction plate must be dust-proof, anti fouling and anti oil. Clutch assembly before the engine to the flywheel and pressure plate surface cleaning, remove the oil, to prevent slipping of the clutch. />2  , 3, & nbsp; & nbsp; & nbsp; in order to guarantee the stationarity of the clutch, clutch pressure plate assembly and a driven disc assembly factory has carried on the balance and use never arbitrarily demolition replacement parts. When the clutch is repaired, it must be disassembled. It is ready to be marked, then assembled and re balanced according to the original mark. < br />4, & nbsp; & nbsp; & nbsp; on the engine assembly or disassembly of the clutch, must be diagonal alternation and tighten or loosen clutch fixed on the flywheel bolts or nuts. />5  , 6  , 7  , 8, & nbsp; & nbsp; & nbsp; clutch in engagement state, separation bearing and the separation between the ring should maintain a gap of 2 ~ 3mm, ready to wear in the friction film, not hinder the platen compressing the friction piece to ensure reliable transmission of engine torque, normal work for a period of time, new car run 2 ~ 3, 000 kilometers, make up the insurance should be adjusted, after every 6000 kilometers do adjustment. />9  , 10 11, handling should be handled with care, can not throw touch. In handling, do not grasp the separation ring, so as not to cause the distortion of the torsion spring. />12 13