EQ1230:420 clutch driven disc assembly

Quick Details

Diameter * diameter * thickness, inner diameter of the spline tooth number X: 420 x 220 x 10 - 10 x 44.5 (bond length of 4.5cm/ bond length 6cm) models: Cummins EQ6CT8.3 engine, YC6112 Yuchai, Weichai Steyr heavy truck models: WD615, CQ1190, CQ1300, CQ1260 Hongyan Sitaier, Scania, S420, FOTON AUMAN 3280, HFF6120GD EQ1242, EQ3242, Ankai, Qingqi XA12 tons, 15 tons, 16 tons of Liberation (DEUTZ engine) car, Jinlong bus, Yutong Bus, Daewoo bus these products are for informational purposes only note the use of
1, driven disc assembly should be kept clean, the friction plate must be dust-proof, anti fouling and anti oil. Clutch assembly before the engine to the flywheel and pressure plate surface cleaning, remove the oil, to prevent slipping of the clutch. />2  , 3, & nbsp; & nbsp; & nbsp; in order to guarantee the stationarity of the clutch, clutch pressure plate assembly and a driven disc assembly factory has carried on the balance and use never arbitrarily demolition replacement parts. When the clutch is repaired, it must be disassembled. It is ready to be marked, then assembled and re balanced according to the original mark. < br />4, & nbsp; & nbsp; & nbsp; on the engine assembly or disassembly of the clutch, must be diagonal alternation and tighten or loosen clutch fixed on the flywheel bolts or nuts. />5  , 6  , 7  , 8, & nbsp; & nbsp; & nbsp; clutch in engagement state, separation bearing and the separation between the ring should maintain a gap of 2 ~ 3mm, ready to wear in the friction film, not hinder the platen compressing the friction piece to ensure reliable transmission of engine torque, normal work for a period of time, new car run 2 ~ 3, 000 kilometers, make up the insurance should be adjusted, after every 6000 kilometers do adjustment. />9  , 10 11, handling should be handled with care, can not throw touch. In handling, do not grasp the separation ring, so as not to cause the distortion of the torsion spring. />12 13